6
Installations using FLEX BLOWER only:
7. Attach
BLOWER SUPPORT LEGS
with
(4) SCREWS
provided.
BLOWER
SUPPORT
LEGS
(4) SCREWS
CAUTION: If flex blower will be mounted remotely:
Do not use legs alone for support. It may be
necessary to add extra support for the flex blower.
Use mounting brackets supplied with the blower.
Installations ducting through left, right or rear only:
(Requires purchase of 1-7/8" x 19" to 8" or 10" round transition
and 1-7/8" x 19" rectangular duct cut to appropriate length.)
8. Use utility knife to cut aluminum tape and remove only one
RECTANGULAR DISCHARGE COVER
.
RECTANGULAR
DISCHARGE COVERS
(Cut aluminum tape and remove
only one cover.)
This Front Panel
remains in place.
Installations where ELECTRICAL PANEL needs to be
mounted in a remote location only:
6. Remove
(4) #8-32 HEX NUTS
and
ELECTRICAL PANEL
. 5-ft.
extension cables (purchase separately) may be needed to
mount electrical panel in a remote location. Do not use more
that 2 extension cables.
Installations ducting through left, right or rear only:
(Requires purchase of 1-7/8" x 19" to 8" or 10" round transition
and 1-7/8" x 19" rectangular duct cut to appropriate length.)
9. Beneath the rectangular discharge cover just removed - Use
a pliers to bend
(6) TABS
outward 90
0
. Use these tabs to
connect 2" x 19" rectangular ductwork or 2" x 19" to 8" or
10" round transition to housing when installing ductwork.
(6) TABS
Ducting out right side of housing
shown.
#8-32
HEX NUTS
IMPORTANT: Regardless of blower placement/
exhaust, ensure that all seams are properly taped
- to make them secure and air-tight. This includes
seams/gaps between panels and/or on the blower.
