Viglen Vig565s, Руководство пользователя

Страница: 25 / 86

Vig565s Motherboard Manual
24
Front Panel Connectors
The following are all connectors situated along the front edge of the motherboard.
They are often connected to buttons and LED’s situated on the front panel.
Figure 6: Front panel connectors
Hard Disk L.E.D. Connector
This goes to the Hard Disk L.E.D. on the front panel, which lights up when the IDE
Hard Disk is in use.
Reset switch connector
When these pins are shorted, it will cause the computer to perform a cold reboot.
Power L.E.D.
This attaches to the power L.E.D on the front panel, to display if the computer is
active or not.
Power On/Off
When these pins are shorted it turns the computer on and off.
Floppy Drive Connector
This connector is for the provided floppy disk drive (FDD) signal cable. Insert one
end of the cable to this connector, and then connect the other end to the signal
connector at the back of the floppy disk drive.
Note: Pin 5 on the connector is removed to prevent incorrect cable connection when
using a FDD cable with a covered Pin 5.