background image

VZ-WM60

Page 2 

Visit the ViewZ website at http://www.viewzusa.com

 

Installation Instructions

Contact ViewZ with any questions: 

(888) 99-ViewZ

techsupport@viewzusa.com

Contents

PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS SHOULD BE READ AND 

 

COMPLETELY UNDERSTOOD. THE INSTALLATION INSTRUCTIONS MUST BE READ TO PREVENT PERSONAL INJURY AND 
PROPERTY DAMAGE. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE REF-
ERENCE.
VIEWZ DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY VIEWZ PRODUCT FOR PUR-
POSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE CAUSED BY UNAUTHORIZED 

 

ATTACHMENTS OR MODIFICATIONS, AND IS NOT RESPONSIBLE FOR ANY DAMAGES, CLAIMS, DEMANDS, SUITS, 

 

ACTIONS OR CAUSES OF ACTION OF WHATEVER KIND RESULTING FROM, ARISING OUT OF OR IN ANY MANNER 

 

RELATING TO ANY SUCH USE, ATTACHMENTS OR MODIFICATIONS.
THE SURFACE MUST BE CAPABLE OF SUPPORTING AT LEAST FIVE TIMES THE WEIGHT OF THE FLAT PANEL. IF NOT, THE 

 

MOUNTING STRUCTURE MUST BE REINFORCED. THE MAXIMUM WEIGHT THAT CAN BE USED WITH THIS PRODUCT 

 

IS 130LBS. PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN, AS OUTLINED IN THE 

 

INSTALLATION INSTRUCTIONS, MUST BE ADHERED TO. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL 

 

INJURY, OR EVEN DEATH.
SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE ASSEMBLY OF THIS PRODUCT. USE PROPER SAFETY 
GEAR AND TOOLS FOR THE ASSEMBLY PROCEDURE TO PREVENT PERSONAL INJURY.

At least two qualified people should perform the assembly procedure. Injury and/or damage can result from dropping or mishandling the  
flat panel.

If mounting to studs, make sure that the mounting screws are anchored into the center of the studs. Use of an edge-to-edge stud finder is  
recommended.

Be aware of the mounting environment. If drilling and/or cutting into the mounting surface, always make sure that there are no electrical wires 
in wall. Cutting/drilling into an electrical line may cause serious injury.

Make sure there are no water lines inside the wall where the mount is to be located. Cutting/drilling into a water line may cause severe water 
damage to the mounting surface.
This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.

Do not install near sources of high heat. Do not install on a structure that is prone to vibration, movement or chance of impact.

Warning Statements

Weight Limit

Maximum Flat Panel Weight: 

175 lbs.

THE WALL STRUCTURE MUST BE CAPABLE OF SUPPORTING 

AT LEAST FIVE TIMES THE WEIGHT OF THE FLAT PANEL. IF 

NOT, THE WALL STRUCTURE MUST BE REINFORCED. 

Weight Limit. ............................................................................................................................................................. 2

Warning Statements. ................................................................................................................................................ 2

Installation Tools. ...................................................................................................................................................... 3

Parts List................................................................................................................................................................... 3

Mounting Hardware. ................................................................................................................................................. 4

Nylon Spacers and Flat Washers. ............................................................................................................................ 4

Features. .................................................................................................................................................................. 5

Wood Stud Installation. ............................................................................................................................................. 6

Concrete Surface Installation. .................................................................................................................................. 7

Universal Spacer Installation. ................................................................................................................................... 9

Universal Washer Installation. .................................................................................................................................. 9

Mounting Bracket Installation. ................................................................................................................................ 10

Fixed Tilt Bracket Installation (Optional). ................................................................................................................ 10

Attaching the Flat Panel to the Wall Plate. ............................................................................................................. 11

Technical Specifications.

 ........................................................................................................................................ 12

Warranty. ................................................................................................................................................................ 13

Disclaimer ............................................................................................................................................................... 13

Содержание VZ-WM60














Отзывы: