ViewZ VZ-CMK04, Руководство по установке

Страница: 11 / 22

VZ-CMK04
Installation Instructions
Visit the ViewZ website at http://www.viewzusa.com
Page 11
Safety Knurl Knob Installation
The safety knurl knobs keep the flat panel from
being accidently dislodged from the VZ-CMK04.
1) Fully extend the flat panel away from the wall.
2) Install and tighten a safety knurl knob at the top of
one of the mounting brackets.
3) Repeat steps 1 and 2 for the other safety knurl
knob.
Safety Knurl Knob
(1 per Bracket)
Panelock™ Installation
Panelock ™
Hook
Security Head
Wrench
M6 x 12mm
Security Head
Screw
Panelock ™
Hook
Security Head
Wrench
If you chose not to install the safety knurl knobs
and instead chose to use the Panelock ™ , skip this
section and proceed to the Panelock ™ Installation
section below.
The Panelock ™ is a theft deterent device. It comes
with security hardware that requires a special tool
that is used to install and remove the security head
screws.
If the safety knurl knobs were previously installed,
they must be removed prior to installing the
Panelock™ hardware.
1) Slide the Panelock™ onto the top mounting rail,
placing the Panelock™ to the outside edge of the
flat panel bracket.
Be sure that the Panelock™ is facing in the same
direction as shown in the illustration to the right.
2) Insert and tighten one (1) M6 x 12mm screw to
attach the Panelock™ to the flat panel bracket.
Repeat and to attach the remaining
Panelock™.
Proceed to “Tilt Adjustment” on page 12.