VZ-CMK04
Page 20
Visit the ViewZ website at http://www.viewzusa.com
Installation Instructions
Part 3 Installation Instructions
Introduction
This 1.5 in. adjustable-height suspension adapter allows
the height of the display or projector to be adjusted
within a range of 24 - 46 in.
(60.96-116.84cm) in 1.25 in. (3.18cm) increments.
Installing the VZ-CMK-P3
Are you attaching the VZ-CMK-P3 to a single stud
or a concrete surface?
If a
single stud,
continue to the
“Single Stud”
section below.
If a
concrete surface,
go to the
“Solid Ceiling
Surface”
section on page 2.
The ceiling should be capable of supporting at least five
(5) times the weight of the product that will be used with
this accessory. If the surface cannot support this weight,
it must be reinforced. Proper installation procedure
by qualified personnel as outlined in the installation
instructions must be adhered to. Failure to do so could
result in serious personal injury.
Solid Ceiling Surface Installation
Single Stud Installation
Use suitable, commercially available hardware to secure
the VZ-CMK-P3 to the stud using the two mounting
slots.
Use suitable, commercially available hardware to
secure the VZ-CMK-P3 to the ceiling surface using the
four corner mounting holes.
Height Adjustment
Make sure to hold the flat
panel, or projector, securely
and remove it from the
mount to make the height
adjustment prior to loosening
the adjustment screws.
Loosen, remove, adjust then
re-tighten the screws. Failure
to do so could result in injury
and or damage to the flat
panel or projector.
1) Remove the adjustments
screws to adjust the height.
2) Re-insert adjustment screws
into holes once pipe is at the
desired length.
