VZ-CMK04
Page 12
Visit the ViewZ website at http://www.viewzusa.com
Installation Instructions
Locking Safety Screw Installation
The locking safety screws keep the flat panel from
being accidently dislodged from the VZ-CMK04.
1) Thread an M6 x 30mm locking safety screw at the
bottom of one of the mounting brackets.
2)
Use a Phillips head screwdriver to tighten the
locking safety screw.
3) Repeat steps 1 and 2 for the other locking safety
screw.
Do not overtighten the locking safety screws.
Tilt Adjustment
Adjusting the Flat Panel Friction Tilt Angle
1) Place one hand at the center top edge of the flat
panel.
2) Place the other hand on the center bottom edge of
the flat panel.
3) Using the upper hand, gently pull the top of the
flat panel towards you while the lower hand gently
pushes the bottom of the flat panel away from you.
Adjusting the Flat Panel to the Original Position
1) Place one hand at the center top edge of the flat
panel.
2) Place the other hand on the center bottom edge of
the flat panel.
3) Using the upper hand, gently push the top of the flat
panel towards the wall while the lower hand gently
pulls the bottom of the flat panel away from the wall.
M6 x 30mm
Locking Safety Screw
(1 per Bracket)
Proceed to the “Installing the Mounting Bracket”
below.
