7
Installation Instructions
Visit the ViewZ USA website at http://www.viewzusa.com
CM 308 series
Leveling the Pole (Top & Middle)
Mounting Monitor-Hold-Bracket(Vesa Plate) to Pole
Installation
1)
You can ensure the pole is properly aligned by tightening the lock
screws/nuts between top & middle, middle & bottom poles.
2)
Place a level on poles(top & bottom) and tighten the screws/nuts (see
illustration on the right).
3)
Check and adjust 2 adjacent sides of the pole until it is plumb in each
direction.
1)
Hold the bottom pole and put 1-3/4" washer between vesa brack and
bottom pole (see illustration on the right).
2)
Gently push the vesa bracket to bottom pole. Vesa bracket is bigger
than bottom pole circumference
3)
You can rotate vesa plate before locking. If you have a desired
direction for the plate, please rotate vesa bracket.
4) After setting the position, use M6xL10 lock screws and lock the vesa
plate.
*NOTE: Avoid over-tightening which can cause the pole to cave.
P
Lock Nut
D
Top Pole
O
Screws
E
Middle Pole
F
Bottom Pole
M
M6xL10 lock
screws
L
φ 44 x φ 38.5 x 2.0
mm Washer
E
Monitor Hold
Bracket
Q
Open Wrench
