8
Installation Instructions
Visit the ViewZ USA website at http://www.viewzusa.com
CM 308 series
Leveling Pole (Bottom & Middle)
Rotation
Installation
1)
You can ensure the pole is properly aligned by tightening the lock
screws/nuts between middle & bottom poles.
2)
Place a level on poles (middle & bottom) and tighten the screws/nuts
(see illustration on the right).
3)
Check and adjust 2 adjacent sides of the pole until it is plumb in each
direction.
1)
Hold the lower pole (where it connects to the monitor) and turn
two lock screws counter-clockwise to loosen the VESA plate (see
illustration on left below). Then, rotate vesa plate to set the position.
2)
Once set in a desired position, lock the two lock-screws by turing
clockwise.
Left Loosen
Hold vesa plate position
and turn two lock-screws as
clockwise to set the position
Hold lower pole section, turn
two lock-screws as counter-
clockwise to rotate vesa plate
Right Tighten
O
M8 x L50 Screws
F
Bottom Pole
P
M8 Lock Nut
E
Middle Pole
Q
Open Wrench
