3
Safety Precautions
P
lease read the follo
wing
Safety Precautions
before you start using the projector.
• Keep this user guide in a safe place for later reference.
•
Read all warnings and follow all instructions.
• Allow at least 20“ (50 cm) clearance around the projector to ensure proper
ventilation.
•
Place the projector in a well-ventilated area. Do not place anything on the
projector that prevents heat dissipation.
•
Do not place the projector on an uneven or unstable surface. The projector may
fall over, causing personal injury or projector malfunction.
•
Do not use if the projector is tilted at an angle of more than 10° degrees left or
right, nor at an angle of more than 15° degrees forwards or backwards.
•
Do not look straight at the projector lens during operation. The intense light
beam may damage your eyes.
•
Do not block the projection lens with any objects when the projector is under
operation as this could cause objects to become heated and deformed or even
cause a fire.
•
Do not attempt to disassemble the projector. There are dangerous high voltages
inside which may cause death if you should come into contact with live parts.
• When moving the projector, be careful not to drop or bump the projector on
anything.
•
Do not place any heavy objects on the projector or connection cables.
•
Do not stand the projector on end vertically. Doing so may cause the projector to
fall over, causing personal injury or projector malfunction.
• Avoid exposing the projector to direct sunlight or other sources of sustained
heat. Do not install near any heat sources such as radiators, heat registers,
stoves, or other devices (including amplifiers) that may increase the temperature
of the projector to dangerous levels.
•
Do not place liquids near or on the projector. Liquids spilled into the projector
may cause it to fail. If the projector does become wet, disconnect it from the
power supply and call your local service center to have the projector serviced.
•
When the projector is under operation, you may sense some heated air and odor
from its ventilation grill. It is a normal operation and not a defect.
