ViewSonic PJ853
4
E
N
G
L
I
S
H
Installation Steps
1
Verify Input/Output Connections
Make sure that you have properly connected all input cables before powering on the projector.
2
Remove the lens cap.
3
Power on the Projector.
•
Turn on the
Main Power Switch
located on the side of the projector. The power indicator will
remain a steady orange. See “Using The Projector” on page 6.
4
Press (and hold for 1 second) the Standby/ON button on the projector control pad.
•
The power indicator flashes green during warm-up.
•
The power indicator will remain a steady green after warm-up. The steady green light indicates
that the ViewSonic PJ853 is ready to use.
•
To shut off the lamp
– Press the Standby/ON button (and hold for about 3 seconds). The unit
will remain in cool-down mode with the fan on and the orange power LED
blinking
for 1
minute. The power switch on the side of the projector may be turned off after 1 minute, when
the power light is a
steady
orange.
5
Position the Projector
Make sure that the projector is properly positioned on a level and stable surface. Determine the
distance the projector will be from the screen then adjust the angle of the projection by
positioning the foot adjusters. (See "Adjusting the Projector Angle on page" 5.)
6
Power on Input Devices
•
Press either the Input button on the projector control pad or the Video/RGB button on the
remote control to select the signal to be projected.
•
The selected input signal source displays in the lower right section of the screen.
7
Adjust the Focus
Turn the lens ring to adjust the focus
Caution:
The projector requires a warm-up period after the power is turned on, and the projector
requires a cool-down period after the power is turned off.
NOTE:
The power cannot be turned on for at least 1 minute after the unit has been powered off; this
is a safety feature.
Figure 4: System Setup
Video recorder with S jack
Video recorder
Desktop Computer
Notebook Computer
ViewSonic
PJ853
(Note: S-video cable not included)
PJ853-.book Page 4 Wednesday, August 16, 2000 11:41 AM
