VIEWONHOME VOH1001, Инструкция по установке и эксплуатации

Страница: 9 / 21

17 16
Usage
Open the case and remove the strip. will start for 30 seconds.
When the sensor is in operation, if it is
triggered more than twice within 3 minutes,
it will switch to standby mode to save power.
If no movement is detected within the next
3 minutes, the sensor goes back to working
mode.
Connect
Register in the control panel
Press the at the back of the control panel to enter the mode.
Press the connect at the back of the sensor or trigger the sensor (by moving in
front of it).
Avoid the detector close to windows, air , heater, refrigerator, oven,
sunshine and places where the temperature changes fast or where the air stream s
frequently.
If two detectors are installed in the same det scope, adjust the loca to avoid interferences
and false alarms.
Fix the bracket on the wall with
screws and ach the detector to the
bracket. Adjust the bracket to change
the det distance and angle. It is
recommended to mount the detector
2m from the ground.
Top
Ground
2.2 m
The detector is more sensitive to
cross movements than vertical
movements.
Side view
Top view
A. the inst turn the detector on. one minute of self-t press the test
walk in the scope of det and watch the LED indicator to make sure the detector
is working.
B. The LED indicator blinks once when body movement is detected.
C. Adjust the detector angle to achieve the best de performance.
Power supply
DC 3V (AA 1.5V LR6 Ba x 2)
St current
≤ 30uA
Alarm current
≤ 15 mA
De scope
8m / 110°
T distance
≤ 80m (in open area)
Radio-frequency
433 MHz (±75 KHz)
Housing material
ABS plas
c
Temparature: -10°C~55°C
R humidity: ≤ 80% (non-condensing)
Detector dimensions (L x W x H)
107 x 53 x 32 mm
Bracket dimensions (L x W x H)
52 x 30 x 26.5 mm
Scope
110°
Top view
0m 2m 4m 6m 8m
2m
0m
Side view