VIEWONHOME VOH1001, Инструкция по установке и эксплуатации

Страница: 8 / 21

15 14
Emergency Mode
Regardless the status of the system, the alarm
is triggered when the SOS " SOS " is
pressed on the remote control.
At the same the control panel sends a
by SMS and dials the pre-stored
phone numbers.
Register in the control panel
Press the at the back of the control panel to enter the mode. Press
any on of the remote control.
Power supply:
DC 3V (CR2025 on ba x1)
Oper current:
≤7 mA
St current:
10 uA
Transmission distance
≤ 80 m (in open area)
Radio-frequency:
433MHz (±75KHz)
Housing material:
ABS plas
c
Temperature: -10°C ~ +55°C
R Humidity: ≤80%
(non-condensing)
Dimensions:
57 x 31 x 11 mm
Wireless Detector
With automa temperature compensa and turbulence technology, it easily
adapts to environmental changes.
Design
Features
3
1
2
1. LED indicator
2. Detection window
3. Bracket
PCB Layout
Alarm zone
setup
Tamper
switch*
Infrared
sensor**
AA 1.5V LR6
Antenna
LED working
indicator
*Tamper switch
When the alarm system is armed, the tamper
switch will trigger the alarm if the case is
opened.
**Infrared sensor
Detects the infrared rays released by human
body Do not touch the surface. K eep
the surface clean.
LED
Blinks self
Blinks once: an intruder is detected
Blinks twice: self is complete; entering working mode.
Blinks once every 3 seconds: under-voltage indica the eries must be replaced. (You will
be informed by SMS when the eries are low if the detector is registered in the control
panel.)
The PIR motion detector is a high performance wireless motion detector boasting a digital
dual-core fuzzy logic infrared control chip with intelligent analysis. This technology identifies
interferences created by body motion and reduces the false alarm rate.