Vienybė EKO ex
Vienybė EKO ex
Vienybe EKO ex (17.01) EN
Vienybe EKO ex (17.01) EN
10
7
6. Technical safety requirements
During use of a fireplace, it is
prohibited to:
- use highly flammable liquids (petrol, kerosene, acetone etc.) to start a fire in the fireplace;
- keep the doors open when the fire is on;
- leave the fireplace to be supervised by young children;
- keep flammable items on the fireplace;
- use fireplace without an ash bin;
- stoke with a barrier removed;
- leave burning fireplace unattended.
It is necessary to periodically clean the chimney from resins and soot in order to prevent fire
hazard. Use metal containers for collection and removal of ashes. Do not pour glowing embers
and ash near flammable surfaces.
Make sure chimney draught is not too strong and no sparks are being thrown.
7. Maintenance
ATTENTION!
Clean the fireplace only when it has completely cooled off.
In order to achieve the best and safe use of the fireplace it is recommended to call specialists
to perform regular fireplace and chimney inspection.
7.1. Glass cleaning
During the normal use of the fireplace no soot or other grime should accumulate on the glass.
Use dry and soft cloth to clean a slightly dirty glass.
Use special non-abrasive glass cleaners to remove stubborn stains.
7.2. Interior and exterior cleaning
In order to achieve effective performance of the fireplace it is necessary to clean interior surfaces
and remove any accumulated resins and soot. Use special cleaners for that. Exterior surfaces
of the fireplace may be vacuum cleaned, or you can use a dry and soft cloth for it.
After several years of use paint of the fireplace may exhibit little color change. You may repaint
the fireplace in order to renew its color. Special heat-resistant paint is available for purchase
from the manufacturer.
7.3. Replacement parts
Parts, such as cast iron fire grate, vermiculite plates, sealant cord etc., may burn out or crack
during use of the fireplace. Replacement parts may be ordered from the manufacturer.
ATTENTION!
Use only original or recommended by the manufacturer replacement parts. Use
of non-original replacement parts for repairs during the warranty period will void the warranty.
4. Installation
The fireplace shall be installed in premises that meet construction standards and requirements.
Installation and connection of the fireplace to a chimney shall be performed in accordance with
"Rules for installation of solid fuel stoves in buildings" ST 8860237.02:1998.
Whilst installing the fireplace it is necessary to comply with local regulations, including any
references to local and European standards.
The fireplace shall be installed by a qualified specialist or a person who has experience in such
work. The fireplace shall be installed in such a way that air supply and control valves 5 and 6 are
not blocked in any way (see Fig. 1.).
4.1. Place of installation
The fireplace shall be installed on a fireproof surface which is strong enough to bear the weight
of the item. When the fireplace is installed on a non-fireproof floor, at least 1 mm thick metal sheet
or any other insulation material must be placed underneath it.
Measurements of the sheet must exceed the measurements of the fireplace in the following
way: from door 0,5 m, from sides and back 0,1 m. Any combustible covering such as linoleum or
carpeting under the sheet must be removed.
Distance from the door of the fireplace to any combustible wall must be at least 1,25 m; distance
from walls and back to any combustible wall must be at least 0,5 m.
The fireplace must be installed in a way that there would be enough space for cleaning of the
fireplace itself, as well as flue and chimney.
It is necessary to supply sufficient amount of fresh air into premises where the fireplace is
installed. When the fireplace is used the supply of fresh air should be up to 15 m
3
per hour. In case
there are any other heating devices installed in the same room, it is necessary to make sure there
is sufficient air supply to all heating devices. For this reason a vent hole with protective grating
may be installed. It is necessary to make sure the vent hole is not blocked by any foreign objects
and that it cannot close itself.
Содержание EKO ex
Страница 2: ......