Videotec MEDUSA, Инструкция по эксплуатации

Страница: 7 / 74

EN - English - I
nstruc
tions manual
5
6.2 Installation
6.2.1 Installing the housing
g
This operation must be carried out with
the power supply disconnected.
Attach the bracket firmly at the chosen spot.
Remove the housing cover by undoing
the 4 screws on the top and leave it
hanging from the anchorage cable.
Fig. 3
Insert the housing body into the coupling seat
provided and fasten it down immediately using
the two screws supplied with the support.
Fig. 4
h
When carrying out these operations
take care not to scratch the dome.
6 Installing and assembling
h
Only specialised personnel should be
allowed to install and assemble the device.
6.1 Assembly
6.1.1 Assembling the plate
with the cable glands
This section describes how to assemble the plate
with cable glands that is supplied with the housing.
Attach the cable glands facing the direction
shown, taking care to tighten the nuts properly.
Fig. 1
Attach the gasket by inserting the
screws into the holes in the plate and
then into the holes in the gasket.
Fig. 2
h
If you are using a self-adhesive gasket
attach it to the plate in the same position.
The plate is now ready for installation in the housing