http://www.videopark.com.cn
Email:
50
Enable P2P by clicking OPEN, and click OK to finish the device configuration.
[Enable]: Open or Close.
[Transfer Mode]: Fluency/Latency/None.
[Device ID]: Each serial number Of devices are different, this cannot be modified.
[Password]: This is generated by the system, you can change it.
[Local Port]: Default is 3000, can be modified.
[State]: Check the connect status of the device and the server.
Remark: When it shows Offline, click
【
Ping
】
to check the connect status again.
Note: If the status still shows offline, please check the if the network light is on, and the device is connected or not.
4.4.4. ALARM CONFIGURATION
Local alar
Local Alarm
Diagram 4- 18
【
Alarm Input Channel No.
】
select the alarm input channel
【
Enable
】
the specified alarm in /out
【
Type
】
select the alarm circuit type.
【
Process Mode
】
enter alarm linkage interface: