5
3. Cut a 3-1/2” diameter round hole into the front side of the ceiling tile centered
on the string. It is strongly recommended to score the front of the tile with a
sharp utility knife prior to cutting the tile. The camera module bezel (front
ring) will fit into the 3-1/2” opening from the rear of the tile (see Figure 2).
Figure 2: Side View – Camera Module Enclosure
Bezel (front ring)
4. Attach the tile support rails with the aluminum positioning clips to support the
weight of the camera on the ceiling tile and between the ceiling grid runners.
Attach the positioning clips as shown to the tile support rail and to the camera
module enclosure fin. Slide the tile support rail through the clip into position
(see Figures 3 & 4) and tighten down firmly.
Figure 3: Enclosure with Tile Support Rails Attached
Figure 4: Positioning Clip Attached to Rails
Note: Attach Clip to Rail and Enclosure Fin as Shown
