14
INSTALLATION MANUAL
3. XTO-IP FEATURES GUIDE
XTO-IP
Alarm panel
When in the ‘Arm From Host’ mode, the Videofied system will only arm and disarm when 9-12v is supplied and sustained.
When both arming inputs are supplied voltage at the same time the Videofied Keypad display will show ‘SYSTEM ARMED.
When only one arming input is supplied voltage the Videofied Keypad display will show ‘PART LVL #’
•
Arming Input 1 will arm/disarm Areas 1 & 2 – Area 1 is delayed by default
•
Arming Input 2 will arm/disarm Areas 3 & 4– Area 3 is delayed by default
3.3 Arming and Siren Mode Configuration
For each arming mode, it is possible to specify how each of the 4 areas will be armed and how the system will behave during an alarm.
Areas :
1
2
3
4
Each time you press the corresponding number, the system will toggle the arming
state for the respective area.
State
:
A A A A
Press
OK / YES
after this configuration step. The system will then display what siren mode
will be in effect for this special profile. Select the siren mode using the direction arrows then
press
OK / YES
.
A
Armed
D
Disarmed
P
Perimeter
(by default : all opening contacts*)
E
External
(by default : all opening contacts
with external access*)
* You can set your devices as : External, Perimeter, ou ExPerimeter. Please go to the menu:
CONFIGURATION (LVL 4) -> AREAS AND DEVICES -> DEVICES -> DEVICES CONFIGURATION -> DEVICE TYPE
Siren
Immediate triggering of all sirens
Delay Beeps
Entry/Exit delay beeps, then triggering of all sirens
Silent
No Sirens, No Beeps
Without Siren
Beeps on the keypad only
•
Use the
to go to menu :
CONFIGURATION
(LEVEL 4) > S
PECIAL ARMING MODES >
FULL ARM, SP1 or SP2
use direction arrows to select the arming mode you
want to modify and
OK / YES
.
•
There are 3 different arming modes :
FULL ARM : Arming of all areas and all devices. Use a badge or a user code and press
OK
/ on the XMA/XMB keypad or the
YES
key on the CMA keypad.
SP1 : Partial Arming (1) is enabled by entering the user code and pressing on the XMA/XMB keypad, the key on the CMA
keypad or on the remote keyfob RC.
SP2 : Partial Arming (2) is enabled by pressing the key on a XMA/XMB keypad, on a CMA keypad, or on the remote
keyfob RC.
