7
5. How to...
Areas : 1 2 3 4 Each time you press on the number
of the area it modifies the correspondance.
State : A A A A Situated below. Validation at the end, the
[YES] key.
A
Armed
Siren
Immediate triggering
of all sirens
D
Disarmed
Delay
beeps
Entry/Exit delay
beeps, then triggering
of the sirens
P
Perimeter
(all the opening
contacts)
Silent
Without siren
without beeps
E
External
(opening
contacts protecting an
exterior access)
Without
siren
Beeps on the
keypad only
6.6 Deactivatethe panic button of the keypad (red
button)
With direction arrows
go to the menu
PROGRAMMABLE FEATURES
->
PANIC BUTTON
ENABLED
Validate with the [YES] key. Use direction arrows to
modify the state. Validate with the [YES] key. Enter the installer
code if need to be in Level 3 or higher.
6.7 Re-engage the panel’s siren following the addi-
tion of an interior siren.
The addition of an interior siren will inhibite the panel siren, which
can however be reactivated.
To do this then go to the menu :
CONFIGURATION
(Access Level
4 + installer code + [YES]) ->
AREAS AND DEVICES
->
SIREN
PANEL
+ [YES]. Chose the authorized state.
6.8 Delete the Entry beeps report of the interior
sirens
When a interior siren is added, the delay beeps are automatically
sounded through it. It is possible to remove them from the menu :
CONFIGURATION
(Access Level 4 + installer code + [YES]) ->
AREAS AND DEVICES
->
DELAY BEEPS
+ [YES]. Chose the
inhibited state.
6.9 Reinitializing a panel
NOTICE : Re initializing the panel will clear any programming
Press 8 seconds on the PROGRAM Button of the panel (the
indicator should flash 2 times).
6.10 Add a device after an initial configuration
With direction arrows
go to the menu
CONFIGURATION
(level 4 + installer code) ->
AREAS AND
DEVICES
. Validate by the [YES] key,
DEVICES
appears, press
on the [YES] key,
ADD A DEVICE
press on the [YES] key
PRESS PROGRAM BUTTON OF DEVICE
record the device
by pressing on the PROGRAM BUTTON.
Be careful : If you add a device in a previously used area, it will
be necessary to modify arming modes (Cf. 5.5) in order to take
into account this new area only on versions pre v32.xx.
Panel PROGRAM
BUTTON
REM : It is imperative to
leave the cover of the panel
open !
LED
