Victron energy EasySolar 12 1600, Руководство пользователя

Страница: 24 / 160

22
Problem Cause Solution
The charger is not
functioning The AC input voltage or
frequency is out of range Ensure that the input voltage is
between 185Vac and 265Vac, and
that the frequency matches the
setting
The thermal circuit breaker has
tripped Reset the 16A thermal circuit
breaker.
The battery is not
being charged fully Incorrect charging current Set the charging current at
between 0.1 and 0.2x battery
capacity
A defective battery connection Check the battery terminals
The absorption voltage has been
set to an incorrect value Adjust the absorption voltage to
the correct value
The float voltage has been set to
an incorrect value Adjust the float voltage to the
correct value
The internal DC fuse is defective Inverter is damaged
The battery is
overcharged The absorption voltage has been
set to an incorrect value Adjust the absorption voltage to
the correct value
The float voltage has been set to
an incorrect value Adjust the float voltage to the
correct value
A defective battery Replace the battery
The battery is too small Reduce the charging current or
use a battery with a higher
capacity
The battery is too hot Connect a temperature sensor
Battery charge
current drops to 0
when the
absorption voltage
is reached Alt. 1: Battery overtemperature
(> 50°C) - Allow battery to cool down
- Place battery in a cool
environment
- Check for shorted cells
Alt 2: Battery temperature sensor
faulty Unplug battery temperature sensor
from the MultiPlus.
Reset the MultiPlus by switching it
off, then wait for 4 seconds and
switch it on again
If the MultiPlus now charges
normally, the battery temperature
sensor is faulty and needs to be
replaced