Victaulic TM-HCT908, Инструкция по эксплуатации и техническому обслуживанию, Страница: 9 / 16

INSTALLING THE HOLE SAW
1. Thread or push the locking ring of the arbor
assembly back as far as it will go .
2. Thread the hole saw onto the arbor assembly
enough to line up the holes in the top of the hole
saw with the drive pins on the arbor assembly . If
the pins do not line up with the holes, back off
the hole saw to line up the holes with the drive
pins .
3.
Thread or push the locking ring of the arbor
assembly down until the pins engage the holes
in the top of the hole saw . Ensure that the hole
saw is flush with the arbor assembly and that
the hole saw is installed firmly onto the arbor
assembly .
TOOL SETUP
WARNING
• DO NOT connect the tool to the
electrical source until instructed
otherwise.
Accidental startup of the tool could result
in serious personal injury.
NOTICE
• When selecting the hole location, take
into account the width of the product
being installed. Ensure that the product
will not interfere with couplings or other
system components. In addition, allow
room on the pipe/tubing for mounting the
hole cutting tool.
1.
Ensure that the pipe/tubing is secured before
attempting to set up the tool .
2. Locate the center of the hole to be cut on the
pipe/tubing run . Mark this center point clearly
with a punch .
9
REV_C
TM-HCT908
/ Operating and Maintenance Instructions Manual