Victaulic TM-HCT908, Инструкция по эксплуатации и техническому обслуживанию

Страница: 14 / 16

MAINTENANCE
DANGER
• Before performing any
maintenance on the
tool, disconnect the
power cord from the
electrical source.
Failure to follow this
instruction could result in
death or serious personal
injury.
LUBRICATION
HCT908 Hole Cutting Tool components are
lubricated at the factory . However, periodic
lubrication of the following parts will maintain
proper operation of the tool .
1. Lubricate the feeder rod with light-grade oil .
2. Lubricate the bearing with light-grade oil .
ADJUSTING THE GIB
If play develops at the gib, which allows
excessive side-to-side movement of the drill
motor assembly, use the adjustment screws on
the tool to correct the problem .
1. Loosen the lock nuts, and use the adjustment
screws to take up any slack .
2.
While holding the adjustment screws in place,
re-tighten the lock nuts . Check the sideways
movement of the drill motor assembly . Using the
feeder knob, run the drill motor assembly up
and down to check for excessive drag . The drill
motor assembly should have minimal sideways
motion, and minimal drag should be produced
when the feeder knob is rotated .
PARTS ORDERING
INFORMATION
When ordering parts, the following information
is required for Victaulic to process the order and
send the correct part(s) . Parts can be ordered
by calling 1-800-PICK-VIC .
1.
Tool Model Number
2. Tool Serial Number
3.
Quantity, Item Number, Part Number, and
Description
4.
Where to send the part(s) – Company
Name and Address
5.
To whose attention to send the part(s) –
Person’s Name
6.
Purchase Order Number
7. Billing Address
14
REV_C
TM-HCT908
/ Operating and Maintenance Instructions Manual