Switch –
shown in
forward
position
Trigger
9.
Ensure that the switch on the underside
of the drill motor’s handle is in the “forward”
position, as shown above .
10.
To install the cord, align the three prongs
of the connector with the receptacle in the drill
motor’s handle . Push the connector in, then
turn the connector one quarter turn clockwise
to lock the cord in place .
DANGER
• To reduce the risk of
electric shock, check
the electrical source for
proper grounding.
Failure to follow this
instruction could result in
death or serious personal
injury.
11.
Plug the cord into an appropriate
outlet or extension cord . Refer to the “Power
Requirements” section .
NOTE:
All of the settings shown are based on
using Milwaukee™ 4/6 Bi-Metal Hole Saws or
Victaulic Hole Saws .
TOOL OPERATION
WARNING
• NEVER use the HCT908 Hole Cutting
Tool for applications where spark
hazards exist or where contact with
water can occur.
Failure to follow this instruction could
result in serious personal injury.
NOTICE
• To extend hole saw life, apply thread-
cutting oil to the hole during the cutting
operation.
1.
Depress the trigger on the underside of
the drill motor’s handle . Feed the hole saw by
turning the feeder knob clockwise . Feed the
saw into the cut at a moderate rate to maintain
smooth cutting action . DO NOT feed the saw
too fast, since it can cause the motor to stall . If
difficulties occur during the cutting operation,
refer to the “Troubleshooting” section .
2.
After completing the cut, release the trigger
completely . Retract the hole saw by turning the
feeder knob counterclockwise .
™
Milwaukee is a registered trademark of Milwaukee Electric Tool
Corporation
11
REV_C
TM-HCT908
/ Operating and Maintenance Instructions Manual
Содержание TM-HCT908
Страница 2: ......