Vicon VSW-16RS232, Руководство по установке и эксплуатации, Страница: 22 / 34

16
••••
Programming XX079-00-01 Rev 303 Video Switchers
A cluster of up arrows (the selection cursor) point at the date format. Use the up or down arrow key to select
AMER, EURO, or ASIA. Then use the right or left arrow key to move the selection cursor to the first date
position and enter the day, month, or year as determined by the format. Program all three date elements and
the day of the week (WD). Press ENTER to set the date or press BACK or RUBOUT to abort.
To set the time, select Set Time from the Main Menu to display the Set Time menu:
Set Time
HH:MM:SS
TIME: 05:58:15AM
↑↑
Use
↑↓
: To Change Digit
Use
←→
: To Select Digit
Enter: To Set Time
Back: To Abort
The up arrow cursor is located under the hour position. In the example shown, AM is displayed at the end of
the line. This indicates that 12-hour mode has been selected. To select the 24-hour mode, hold down the up
arrow key until the AM and PM designations have disappeared. The lack of an AM or PM indicates that the
time is now in the 24-hour mode. To set the time to the nearest second, set the minutes position to one or two
minutes ahead of the reference clock and set the second to 00. When the reference clock reaches 00
seconds of the specified minute, press ENTER. This starts the system clock. To abort, press BACK or
RUBOUT.
Programming EZ-A (or B) Sequence
The selection of sequencing cameras for each monitor is done through line G, the Edit EZ-A Sequence menu
(for Monitor A) or line H, the Edit EZ-B Sequence (for Monitor B). Also, the dwell time for all the cameras
sequencing for Monitors A and B can be set from 1 to 60 seconds. To program the camera sequencing for
each monitor, bring the arrow cursor to either line G or H (from the Main Menu) and press the right arrow key.
A submenu is displayed (for Monitor A in this example) as follows. (Note that cameras 9 – 16 are only
accessible on 16-channel units, even though the numbers appear on the menu for 8-channel units.)
Edit EZ-A Sequence
01 02 03 04 05 06 07 08
XX -- XX XX XX XX XX XX
09 10 11 12 13 14 15 16
XX XX XX XX XX XX XX XX
Dwell:01
Shift
↑↓
: To change dwell
Shift 5: To exit
The numbers 01 to 16 represents the camera inputs. Press the number key on the front panel for the
associated camera input to toggle between XX or --. The XX symbol below the camera number indicates that
the camera is selected as part of the sequence for Monitor A. The -- symbol below the camera number (in this
example, camera 02) indicates that the camera is not selected as part of the sequence for Monitor A. The
number to the right of Dwell indicates the switching time between cameras. The functional description for
Monitor B’s menu is the same as Monitor A’s menu.