Vicon VSW-16RS232, Руководство по установке и эксплуатации, Страница: 10 / 34

4
••••
Installation XX079-00-01 Rev 303 Video Switchers
Figure 1
8-Channel Front and Rear Panel
Figure 2
16-Channel Front and Rear Panel
Video Inputs and Looping Outputs
The video switchers are designed for 1.0 volt peak-to-peak baseband composite video signal. Use only
coaxial cable types. See Coaxial Cable Recommendations.
Connect a coaxial cable from each camera to one of the VIDEO IN BNCs. If the video is to be run to other
devices, such as a dedicated monitor or VCR or to a matrix switcher, connect a coaxial cable from the desired
VIDEO OUT BNC to the other equipment. A dedicated monitor or VCR only displays the video of a single
camera. If the video switcher is integrated into a matrix switching system, each video input should be looped
out to the switcher. Each VIDEO OUT connector that is not used must be terminated with a 75-ohm
terminating plug.
Note: Unused looping outputs that are not terminated may cause degradation of the monitor image.