Vicon VSW-16RS232, Руководство по установке и эксплуатации, Страница: 13 / 34

XX079-00-01 Rev 303 Video Switchers Programming
••••
7
Programming
Setup
All programming and operation of the unit is carried out with the front panel buttons. The group of buttons on
the left-hand side is used for programming. The number on each button refers to a corresponding video
channel and does not have significance in the programming setup.
The left-hand button of the programming group is the SHIFT key. All the functions labeled above the other
keys are carried out in conjunction with the SHIFT key. The keys labeled MONITOR A/B, SEQUENCE
START, SEQUENCE EDIT, VIEW, and ACK are used in normal operation rather than in setup and are
discussed the Operation section.
Setup is carried out using the functions identified under keys 2 through 8, including up, down, left and right
arrows, REMOVE, RUBOUT or BACK, and ENTER.
Note: To display the programming menu, it is necessary to be connected to MON A.
When the unit is connected to a power source, the following screen is displayed:
VICON INDUSTRIES INC.
89 ARKAY DRIVE
HAUPPAUGE, NY 11788
VIDEO SWITCHER
VERSION 1.00
Some additional characters may be displayed at the bottom of the screen. After pressing any front panel
button, setup can be started.
Menus
To view the Main Menu, be sure that the monitor is connected to Monitor A. Display the Main Menu by
pressing and holding the SHIFT key and then pressing the MENU key. The Main Menu displays:
A. Exit Menu
B. Camera Setup
C. Monitor Setup
D. Alarms
E. Set
Date
F. Set Time
G. Edit EZ-A Sequence
H. Edit EZ-B Sequence
I. Change Passcode
Note: If the passcoding system has been activated, lines G, H and I will display a solid block,
!
, in place of
the line letter. If these blocks are in place, refer to the Reset Menu section for instructions on how to
access a passcode-protected unit.