XX176-00-00 Rev 507 VNCTRL-1 Remote Control Panel
Appendix 1
•
17
Appendix 1
After the VNCTRL-1 is installed and setup, the software must be configured. Perform the following steps for
the configuration of the software files related to the VNCTRL-1 remote control panel.
1. Restart the ViconNet application and log in.
2. Click the Controls button and select the local unit and VNCTRL-1.
3. The Instruction Window can be moved to the side and/or click on Hide Instructions to remove it
4. Make sure the device shows an online status; if it doesn’t, verify that the correct COM address and baud
rate setting are being used (see ViconNet Setup).
5. Close the ViconNet application and exit to the operating system.
At this stage the configuration files have been created in the following directory:
C:\ViconNet\VNData\Drivers\Controls
You will need to edit the following file:
Vicon CB Def_1.ini
The file contains the following sections that require editing:
1. [Sites]
Comment-NumberOfTransmitters=Number Of Transmitters To Record From
NumberOfTransmitters=1
•
This section indicates the number of video/audio sources this unit will need to record. If you have a
single DVR it will be 1 transmitter, even if you are recording more than 1 camera/mic from it. Two IP
cameras will be considered 2 transmitters.
2. [Site_1]
