Vicon V8360W Series, Руководство пользователя

Страница: 14 / 94

14
2.2 Connections
•
Micro SD memory card
Insert an SD card into the slot on the bottom of the dome. See figure below.
•
Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a cross-over
cable is used for directly connection to PC, while a direct cable is used for connection to a hub. You
can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
•
Connecting Alarms
ALI (Alarm In): You can use external devices to signal the network camera to react on events.
Mechanical or electrical switches can be wired to the ALI (Alarm In) and GND (Ground)
connectors.
GND (Ground): Connect the ground side of the alarm input and/or alarm output to the GND
(Ground) connector.
ALO (Alarm Out): The network camera can activate external devices such as buzzers or lights.
Connect the device to the ALO (Alarm Out) and GND (Ground) connectors.
•
Connecting the Power
Connect the power of 12 VDC for the network camera. Connect the positive (+) pole to the
“+”
position and the negative (-) pole to the
“-” position for the DC power.
–
Be careful not to reverse the polarity when connecting the power cable.
–
A router featuring PoE (Power over Ethernet) can also be used to supply power to the
camera.
–
For the power specifications, refer to the appendix, product specification.
–
If PoE and 12 VDC are both applied, the camera will be supplied with power from PoE.
•
Connecting Audio
Connect speaker to audio line output and external Mic to audio input line.
•
Connecting Test Monitor Out(CVBS)
Connect 2-pin connecter test video cable to check test video.