Select Day/Night mode using external equipment, by connecting control lines to the appropriate
terminals.
2-1. External Day/Night Control(Option)
DAY&NIGHT EXTERNAL INPUT
Switches the cameras D/N mode to either Day or Night based on the input status. Refer to the
diagram below. The cameras CNTL SIGNAL of D/N AUTO mode must be set to EXT2 for this
to function.
2-2. Alarm Out -Open Collector (5V/10mA)
2-4. Camera Control
BROWN : RS 485+
BLUE : RS 485-
2-3. Power Input Terminal
RED & WHITE : These terminals accept 24V AC or 12V DC. When using 12V DC it is
recommended to use a DC power supply that can support an inrush current of 0.55A
DAY&NIGHT INPUT
Gray
GND
Black
●
●
Close contact: NIGHT
Open contact: DAY
1. Lens :
Allows a wide area to be monitored.
2. Color Lead Wire & Color Display Label
3. Video :
BNC connector used to connect the camera to a monitor, swither, etc.
<Connector Option>
Motion detection signals are output through this port. Active state is Low(GND).
Normal : Open Collector, ALARM : Low(GND)
RS 485(+)
AC24V/DC12V
AC24V/DC12V
DN EXT-IN
GRAY
BLACK
GND
RS 485 (-)
Camera connections 7
