Vicon SurveyorVFT SVFT-C266A, Руководство по установке и эксплуатации

Страница: 19 / 36

Camera Power Connections
Note: Vicon systems and components, like most electronic equipment, require a clean, stable power source.
Voltage irregularities such as surges, drops, and interruptions can affect the operation of your
equipment and, in severe cases, damage certain components. Vicon strongly recommends the use of
line conditioners, voltage regulators, and uninterruptible power supply (UPS) systems.
r is connected through a two-position detachable screw terminal connector on the PC board (P8). Refer Powe
to Figure 4. Refer to Table 2 for the input power connections.
2. (25 mm) of insulation off power cables. Then strip off approximately 0.25 in.
prevent incorrect
1. Find the detachable power cable connector supplied on the PC board.
Strip approximately 1 in.
(6 mm) of insulation off each individual wire. Attach the camera power cables to the connector according
to Table 2.
3. Press the cable connector onto the board connector. The connector is keyed to
installation.
The camera is shipped prepared for 24 VAC.
Table 2
Camera Power Connections
Pin Number Function
Figure 4
Camera/Lens PC Board
1 24 VAC Input
2 24 VAC Return
XX152-01-00 Rev 404 SurveyorVFT Fixed Camera Dome Installation
•
9