Vicon ROUGHNECK V-CELL-HD-A, Быстрое руководство по установке

Страница: 7 / 16

V-CELL-HD-A Quick Installation Guide
7
2.2 Cable Connections
All cabling is done to the boards located on the back of the front plate.
1) Micro SD memory slot on the Board
Card Slot for Micro SD memory: Socket “J10.” (SD card customer-supplied.)
2) Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a
crossover cable is used for direct connection to a PC, while a direct cable is used for
connection to a hub.
3) Connecting Alarms

AI (Alarm In):
External devices can be used to signal the network camera to react upon events. Mechanical
or electrical switches can be wired to the AI (Alarm In) and G (Ground) connectors.

G (Ground):
Connect the ground side of the alarm input and/or alarm output to the G (Ground) connector.

Alarm Out:
The network camera can activate external devices such as buzzers or lights. Connect the
device to the AO (Alarm Out) and G (Ground) connectors.
4) Connecting the Power
Connect the power of
12 VDC
for the network camera. Connect the positive (+) pole to the ‘+’ position and
the negative (-) pole to the ‘-’ position for the DC power.

Be careful not to reverse the polarity when connecting the power cable.

A router featuring PoE (Power over Ethernet) can also be used to supply power to the camera.

The heater can be powered by a 12 VDC, or PoE power source.

For the power specifications, refer to the Appendix, Product Specification.

If PoE and 12 VDC are both applied, the camera will be supplied with power from PoE.
5) IR Control
To adjust the intensity of the IR illuminators, use the Day & Night menu in the web browser.
6) Connecting Service Monitor Port
The Service Monitor output port (J1) is located on the front board of the camera and BNC out port is
located on the rear board of the camera.