Control Panel Display Windows
TIME / PROGRAM Window
This window displays session time or play modes.
Play modes include manual control (P0) or
programmed control (P1, P2 or P3)
When the machine is powered on and idle, this
window displays a number 10, indicating the default
session time of 10 minutes. The following functions
can be performed:
Set up session time by pressing the TIME button,
to adjust the session time between 1 minute and
20 minutes.
Set up program by pressing the Program button
(P) to select either manual control P0, or,
programmed control P1, P2 or P3.
When the machine is running, this window displays
the remaining session time and the running program
(P0, P1, P2 or P3), in a 5-second alternating
sequence.
SPEED Window
This window displays the motion speed level.
The speed can be adjusted in 20 levels, cover a
vibration frequency from 5 Hz to 14 Hz.
The speed can only be adjusted when the machine
is running. The default speed level is 1 (5Hz).
In program modes, this window displays the
programmed speed level.
Middle Window – Remote Control Receiver
This window receives remote control signal.
The remote control uses infrared light signal to
transfer orders, therefore it needs to point to this
remote control receiver window to work.
Control Buttons
Buttons Functions
Button
Function
Standby - put the machine to standby, or
wake up the machine from standby.
Functional when power is switched on.
The button is only on remote control.
START/STOP - start or stop the vibration,
PROGRAM - select manual mode P0, or
a program mode, P1, P2 or P3.
Time
TIME (remote control) - set up vibration
session time, from 1 to 20 minutes, when
the machine is powered on but in idle
status.
These two buttons are disabled when the
machine is running.
TIME (control panel) - set up vibration
session time, from 1 to 20 minutes, when
the machine is powered on but in idle
status.
This button is only on the control panel
Speed
SPEED - adjust vibration speed level
from 1 to 20 levels, when the machine is
running on manual control mode.
These buttons are disabled when the
machine is running on program mode.
The remote control
needs to
point to
the
remote receiver window
on the control panel to
work.
