Getting Started
Installing the mOSW-C1 into a MAP-200 Chassis
MAP-200 Optical Switch mOSW-C1 Installation and User Guide
Standard
June 2016
Document Number 22112369-120 R000
Page 28
5. Using the dusting gas or compressed air, blow the end of the ferrule.
6. Apply the alcohol or ethanol to a lint-free pipe cleaner or swab and wipe off
the remaining parts of the connector.
7. With the other end of the pipe cleaner or swab, dry the areas cleaned.
8. Using the dusting gas or compressed air, blow the areas cleaned.
Installing the mOSW-C1 into a MAP-200 Chassis
Cassettes can be installed in a chassis at anytime regardless of whether or not the
chassis is powered. MAP-200 allows for hot-swapping, so the controller detects the
presence and determines the type of cassette that is being added without affecting
the communication with other cassettes. Each cassette has a unique ID, serial
number, hardware version, and firmware version.
The cassettes are an element of the MAP. Cassettes implement a specific
functionality which is directly applicable to optical instrumentation, testing, or
measurement. Different types of instrumentation cassettes can reside in a single
chassis and cassettes can be added in a plug and play manner.
Installation Procedure
Perform the following steps to install a cassette:
1. Remove a blanking plate with a flat-head screwdriver by applying downward
pressure to the tab at the top of the blanking plate. Store the faceplates for
future use.
Figure 10: Removing a Faceplate
2. Slide the cassette into the chassis.
3. Position latch to 45° and when the cassette cannot be pushed in further, push
the latch shut to make the final contact or until the cassette face plate is flush
with the controller.
