The 845G MAINBOARD Series
Page 13
2.3.2. Memory Modules
The mainboard has two 184-pin DDR DIMM slots and are able to support a
maximum memory of 2 GB. The DDR DIMM slots are located on the right hand
side of the board. To install the DIMM
s into these slots, make sure the white
lever at each side of the slot has been pulled down to an angle of
approximately 45°. Make sure that the DIMM is in the correct orientation.
Place the DIMM on the slot and push down firmly.The white levers will come
back up and lock the module in place.
,)' ? + 2,B% ( + % %
.%++2,B%+ +'% C
-( %+)
2.3.1. Installation of the CPU
To install your processor, please complete the following set of instructions
1. Locate a small dot marked on the top of the CPU. This mark indicates
Pin 1 of the CPU.
2. Locate Pin 1 for the Socket on the mainboard.
3.
There is a lever on the side of the socket. First push this lever side-
ways and then lift it to a 90-degree angle.
4.
Insert the CPU into the Socket. Please make sure that Pin 1 for the
CPU is inserted into Pin 1 of the Socket.
5. When the CPU is installed correctly push the lever back into place.
6. Install a proper heat sink with cooling fan for proper heat dissi-
pation. Failing to install a heat sink with cooling fan may cause over-
heating which will burnout your CPU and damage your mainboard.
IMPORTANT: CPU COOLING FAN
Please ensure that you have an approved heat sink with cooling fan. Without a
proper heat sink with cooling fan you will damage both the mainboard and the
CPU.
Hardware Installation
-.& #! " !
!'%
:'%
Top View of a 184-pin DIMM Slot
Supports 64 Mb, 128 Mb, 256 Mb and 512 Mb technologies for x8 and x16 de-
vices. (Double-sided x16 devices are not supported)
