The 845D-MVT MAINBOARD
Page 13
2.4.2. Memory Modules
The mainboard has two 184-pin DDR DIMM slots and are able to support a
maximum memory of 2 GB. The DDR DIMM slots are located on the right hand
side of the board. To install the DIMM’s into these slots, make sure the white
lever at each side of the slot has been pulled down to an angle of
approximately 45°. Make sure that the DIMM is in the correct orientation.
Place the DIMM on the slot and push down firmly.The white levers will come
back up and lock the module in place.
Note: The system memory supports 64 Mb, 128 Mb, 256 Mb and 512 Mb tech-
nologies for x8 and x16 devices (Double-sided x16 devices are not supported).
Hardware Installation
!)'
;)'
Top View of a 184-pin DIMM Slot
9@A*+ B ''/
#%!( :%=) (.%14
(/19 ./191!(! <4
, . !, !,% , ( (
42 !( (1 .,( !, ,
1
, (, ;
6
= (. (% !A.. ( : ! <4
+ &. ! %
6
" ! &%("! (. (% !1(
:
6
= (. ! !(.,( :
, ...(%). *,.'3)*'6 , (
2.4.3. PCI Slots
The mainboard comes with three PCI slots. They are located on the left hand
side of the board. Both PCI and PCI expansion cards may require IRQ’s. This
mainboard complies with Plug and Play (PnP) specifications. Whenever a PnP
compliant card is added the system will automatically be configured and the
IRQ’s will be assigned automatically.
When you are inserting your PCI card
make sure that the pins are correctly aligned. When the pins are properly
aligned with the hole’s in the slot, push down gently.
)'
)'
Top View of a 32-bit PCI Slot
