www.desatech.com
113470-01D
8
Removing Bifold Glass Doors
Remove bifold doors for replacing or cleaning.
1. Partially open each door and press up on
upper spring clip with a screw driver until
outer top pivot pin is free of the clip.
. Fully fold frame assembly and slide upper
edge towards center of firebox opening
until the guide pins are free of the frame
rail (see Figure 1, page 7).
Installing Fixed Glass Doors
1. Hold glass door firmly at both handles and
insert top pins into clips located below up-
per facial edge of firebox opening. Make
sure top pins snap securely into holes on
spring clips (see Figure 14).
. Push up on glass against tension of spring
clips. Swing lower door into face until lower
pins clear bottom rail and set into locating
holes on each end (see Figure 14).
Note
: If pins do not align into spring clips,
slightly loosen retaining screws on each clip
(see Figure 13, page 8). Reinsert panel into
each spring clip and align panel into lower
locating holes. Remove panel, tighten screws
and reinsert panel.
ACCESSORy
INSTALLATION
Continued
Figure 14 - Installing Fixed Glass Doors
Spring Clip
Locating
Hole
OPTIONAL BRICk LINERS
Installing or Removing Brick Liner Kits
These models come standard with red brick
liners. There are white brick liners available
(see
Accessories
, page 6). These brick pan-
els may be installed any time after fireplace
installation is complete.
Follow these steps to install left and right
brick panels:
1. Remove glass doors (if equipped). Follow
instructions under
Optional Glass Doors
,
page 7.
. Remove each retaining screw holding
screen rods and pull entire screen and rod
assembly out of locating hole on inside top
edge of firebox (see Figure 15).
3. Remove log bed from hearth pan and
place in a safe area. Log bed is attached
with contact magnets only.
4. Remove two screws holding each refrac-
tory bracket to firebox. Pull up and lift out
of positioning slot at bottom of hearth pan
(see Figure 16, page 10).
Note
: CE36M
model requires removal of additional
hearth brackets and face panels which
are held in place by screws on hearth
pan and one screw at top retainer bracket
(see Figure 16, page 9).
Figure 15 - Removing Screen/Rod
Assembly
Screen
Rod
Retaining
Screw
Locating
Holes
