www.desatech.com
113470-01D
15
If control assembly needs complete replace-
ment, proceed to remove the entire control
assembly as follows:
1. Remove the glass doors (if equipped).
Follow instructions under
Optional Glass
Doors
, page 7.
. Remove each retaining screw holding
screen rods and pull entire screen and rod
assembly out from locating hole on inside
top edge of fireplace (see Figure 26).
3. Remove log bed from hearth pan and
place in a safe area. Log bed is attached
with contact magnets only. This step is
included to keep logs from being damaged
during panel replacement.
4. Remove Phillips screws holding control
cover to control panel inside firebox (see
Figure 19, page 1).
5. Slide control cover to the right and swing
out locking tabs from notched openings on
top. See detail Figure 19, page 1.
6. Pop out bushings on control cover and slip
power harnesses free from control cover
(see Figure 7).
7. Remove magnet assemblies, deflector
shield and control door. See
Removing/
Replacing Control Door
, page 14.
8. Tilt entire control assembly forward to
clear lower flange at upper door rail and
slide assembly down through space be-
tween the front face and firebox mount
(see detail Figure 8).
9. Angle control panel out through opening
(see Figure 8).
10. Follow these instructions in reverse order
to reassemble control panel assembly.
Note
: Be certain that all wires, harnesses and
bushings are returned to their normal position
and free of damage before reconnecting sup-
ply power to the fireplace.
CAUTION: Note the location
of all wires prior to disconnect-
ing. Be sure to reconnect wires
to their proper locations. If you
are unsure about the proper wire
locations, follow the wiring dia-
gram Figure 18, on page 11.
ACCESSING IMAGING UNIT
The imaging unit can be accessed from inside
fireplace for servicing as follows:
1. Remove glass doors (if equipped). See
Optional Glass Door
s, on page 7.
. Remove screens, grate, hearth pan brack-
ets and brick liners. See Figure 9, page
16 and instructions under
Optional Brick
Liners
, page 8.
3. Remove 4 Phillips screws holding hearth
pan to fireplace and 2 screws located at
lower frame rail (see Figure 30, page 16).
MAINTENANCE
Continued
Figure 27 - Detaching Power Harnesses
LOW
LOW
MAIN
POWER
FLAME SPEED
FLAME BRIGHTNESS
HEATER
Panel Screws
Figure 26 - Panel Screws Location
Figure 28 - Removing Control Panel
Control
Panel
Power
Harnesses
Bushings
Control
Cover
