Vetus DBPPJA, Руководство по установке

Страница: 14 / 64

14
020813.11 vetus®
Installation manual DBPPJA - Proportional panel for bow and stern thruster
ENGLISH
4. Move the joystick to the left or right to set the control panel code. The color of the LED indicates the control
panel group code.
Group A BLUE, flashing
Group B RED, flashing
Group C BLUE and RED,
simultaneously flashing
Group D PURPLE, flashing
OR
4 5
4 .7 Configuration of multiple control panels
1. Place the panel in configuration mode
• Push the joystick to the right, press and hold the "ON / OFF" but-
ton for 10 seconds.
During the first 6 seconds, LED (1) flashes blue and the buzzer will
continuously signal a didididididi ..... (. . . .). Keep pressing the "ON /
OFF" button. After 10 seconds the buzzer sounds the signal didididi-
dah (. . . - -).
1
Carry out the following actions on EACH panel in the order indi-
cated:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first press the "ON / OFF" button once to switch the
panel to the OFF position, see 4.3, and wait 5 seconds before turning
the panel back on).
Set up multiple control panels
You can configure four control panels (Group code A, B, C or D). Use
one group code per control panel.
10 seconds
seconds
Configuration mode
seconds
(1) BLUE, flashing
6
dididididididid ( . . . . . . ) dididididah ( . . . . − )
4
1 x
5. Press the On/Off button
once to confirm the set-
ting.
1 x
1 BLUE, flashing
1
didahdi ( . − . )
2 3
i
mportant
If another combination of LEDs
is lit, first restore the factory
settings (see 4 .5) and start chec-
king the thrust direction again
(see 4 .4) .
1
2
3
2. Press the On/Off button
once.
3. LED (1) flashes blue and you hear the signal, di-dah-di (. -.)
Now the panel is in configuration mode.
3
2
4
5
1
ON/OFF