2
Mounting the saddle bag
at its rear mount
While holding the forward
mount in position, push the
rear mount of the bag to the
side loop tomahawk. Insert
the conehead into its spring
loaded receptical (an audible
"click" will be heard when
the conehead is fully engaged.)
The bag is now mounted and
ready for use.
CAUTION: To avoid saddle bag
damage from muffler heat, a
minimum clearance of 19mm
('4") is needed. To obtain de-
sireable tail pipe clearance it
may be necessary to loosen
saddle bag hardware: apply
upward pressure then tighten
into place. Follow by loosening
muffler; apply downward pres-
sure to muffler, and retighten.
3
Saddle bag removal
To remove the bag, simply
turn the locking key to its
release position, and pull the
rear of the bag out and back to
disengage the forward mount.
NOTE: If the conehead and/or
latch mechanism become
difficult to operate, a thin
layer of oil on the parts should
correct the problem.
NOTE: Use only powdered
graphite on the locks them-
selves for lubricant.
14
