VETRON 5390, Инструкция по эксплуатации

Страница: 70 / 75

68
07/2018
VETRON 5390 - POST BED MACHINE - INSTRUCTION BOOK
07. ERROR CODES
02. ERROR MESSAGES
-1-3
ERROR CODE DESCRIPTION SOLUTION
» BUS ERROR
2 AC voltage is too high
Check supply voltage
3 AC voltage is too low
4 Bus voltage is too high
5 Bus voltage is too low
6 Discharge function error Replace control box
7 Bus current too high Apply main drive overload condition procedure
8 Bus voltage faulty Replace control box
9 31V Overcurrent
» Check all 31V consumers and cables (Bobbin
winder, thread clamp, trimmer, pneumatic
value) for short circuit
» Replace control box
10 Command bus hard fault
» Check cable and connector B1
» Replace control box
60 Right bobbin monitor not connected Check connection of bobbin thread monitor (Y1-A1)
61 Left bobbin monitor not connected Check connection of bobbin thread monitor (Y1-A2)
» SAFETY ERROR
0 Obstacle detected
» Clear area under the foot.
» Avoid obstacles while foot is lowering
1 Timeout reading foot height
Contact VETRON Support
5 Timeout on foot height correction
10 Distance magnet / sensor too high
99 Critical safety module error
» MAIN DRIVE ERROR
100 Main motor encoder error
» Check connector and cable M2
» Replace main drive
»
Replace control box
101 Main drive current zero sample
» Do not turn the machine with hand
after power on
» Replace control box
103 Main drive overload Apply main drive overload condition procedure
104 Main drive hold position overload
Disable hold torque, check if turning the machine
with the mechanical handwheel is smooth while
machine is initialized
105 Main drive current sample Replace control box
NOTE:
The error codes refer to the control box connections. Depending on the machine type and
optional accessories, different functions can be controlled. This has to be considered
during troubleshooting.