Veterinary Ventures Drinkwell 360, Руководство по эксплуатации

Страница: 8 / 13

www.petfountain.com
REASSEMBLY OF YOUR DRINKWELL 360
1) Replace the pump into its location between the 4 half-inch posts in the
center of the fountain. Be sure to position the hole on the top of the pump
next to the Cord Pass-Through in the Bowl. Gently push down to engage
the suction cups.
2) Replace the Intake Tube into the Intake Tube Holder, then place the
Intake Tube Holder back onto the Cord Pass-Through post aligning the
guideline on the post with the notch in the intake tube holder. Be careful
to align the intake tube so that it fits into the hole on the top of the pump.
3) Thread the plug through the opening next to the pump. On the bottom
side of the bowl, clip the cord into place using the “cord clips” (Fig. 13a).
Next, thread the cord directly out the fountain through the cord pass-
through (Fig. 13a & 13b). Use this pass-through to keep the cord from
showing.
4) Align the three notches around the Cone with the corresponding tabs in
the bowl. Next, turn the cone piece to the right (clockwise) to lock tabs
into place. (Fig. 3 & 5)
5) After cleaning your fountain it is a good idea to replace your filter.
6) Screw on Filter Housing Cap and slide the Filter Housing into place in the
hole at the top of the Cone. Turn Filter Housing a quarter turn to the right
(clockwise) to lock in place.
7) Choose your preferred Spout Ring (1 spout up to 5 spouts) and place
on top of the Filter Housing Cap, press it gently into place. Be sure it is
pushed down evenly all the way around.
8) Replace the Flow Control Cap by aligning the cap with the notches on
the Filter Housing Cap and gently pushing down.
9) Place fountain in desired location and fill with water to the MAX fill line.
10) With dry hands reconnect the inline plug and then plug fountain in. Adjust
the flow to your preference and let your pet enjoy the fresh free falling
water of the Drinkwell ® 360 TM .