Veterinary Ventures Drinkwell 360, Руководство по эксплуатации

Страница: 4 / 13

www.petfountain.com
8) Align the side grooves of the Filter Housing
with the inner notches of the cone opening.
The Filter Housing should slide easily into
place. Turn housing a quarter turn to the right
(clockwise) until it locks in place.
(Fig. 9)
9) Select one of the five interchangeable spouts
based upon your personal preference or your
pet’s. Place the chosen spout on top of Filter
Housing Lid and gently press down evenly to
secure in place.
(Fig. 10)
10) Align Flow Control Cap with the raised
notches (Fig. 11) on the Filter Housing Lid.
Press down gently and the cap will snap into
place. With the Flow Control Cap, you will be
able to easily adjust the flow intensity of the
water. Turn the cap to the right to increase the
flow and turn to the left to decrease.
11) Place fountain in desired location. To take
care of your floors,
always
use a protective
mat, such as a towel or place mat. This will
help protect your floor from any water that
may splash out from your pet’s use of the
fountain.
12) Fill the fountain bowl with water. Make sure
the water level is
at least
to the MIN. Fill
Line so the pump does not run dry. This
will prime the pump for use. Do not fill the
fountain past the MAX. Fill Line.
13) Before you plug in the fountain make sure
the cord and your hands are dry. Plug the
fountain in.
14) Add water as needed.
Never
let the water
level fall lower than the MIN. Fill Line (approx.
1” above the bottom of the bowl, Fig. 12)
or the pump may fail. To properly pick up
the fountain, use both hands and grip the
sidewalls of the fountain bowl and lift.
Never
pick up a full fountain by the Cone piece.
Groove
Notch
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Raised Notches