7
■
Installation
Installation Location
WARNING
PROHIBITED
Do not use in environments with flammable gases and solvents in the
atmosphere, requiring explosion-proof equipment. As this product is not
explosion-proof, there is a risk of explosion or fire.
CAUTIONS
CAUTIONS
• Take into consideration the ambient conditions surrounding the installation
location.
• Install indoors where it will be sheltered from wind and rain.
• Install in a location where it will not be exposed to water, oil or fine dust.
• Do not install in locations where considerable vibrations or shocks will
be transmitted to the unit.
• Do not bring into areas with high humidity, or where there are corrosive
gases such as acids, alkalis or chlorine gas present. Also, do not use the
product in these types of areas. There is a risk of electric shock or product
breakdown.
• Please use in areas with a temperature between 0 to 50
℃
, and a
humidity of 10 to 90%.
Installation work
CAUTIONS
REMEMBER
• Installation should be conducted by someone proficient in handling of
electric products, including electric wire.
• This product uses sensitive electronic circuits, so please handle it as
gently as possible and avoid subjecting it to shocks, etc.
• Do not, under any circumstances, drill holes into the unit.
Please install the GP-1 near machinery to which load electrodes (bars, nozzles, air guns, etc.) are
connected. Secure firmly to a strong frame, wall, floor, etc. using 4
×
M5 screw through the holes in
the bottom of the mounting base. When installing the unit on a vertical surface, make sure the high
voltage output connector is downward.
Connecting the wiring
1. Be sure to connect the power adapter connector (accessory) by inserting it securely into the unit
input connector (MOLEX 5557-02R-210).
2.
CONNECT THE AC CABLE TO THE POWER ADAPTER (ACCESSORY), AND BE SURE TO
PLUG THE 3-PIN TERMINAL ON THE AC CABLE INTO A 3-PIN OUTLET WITH A
CONNECTED GROUND. WHEN CONNECTING THE AC CABLE TO A 2-PIN OUTLET THAT
DOES NOT INCLUDE A CONNECTED GROUND, WIRE THE GROUND TERMINAL OF THE
UNIT TO A GROUNDED MACHINERY FRAME, ETC
* IN THIS CASE, MAKE SURE THAT THE POWER SWITCH ON THE UNIT IS IN THE OFF [
○
] POSITION.
CAUTIONS
CAUTIONS
This product must always be grounded. If the product is not
sufficiently grounded, it will not perform up to its full capabilities.
Also, when touching the casing you may receive a light electric
shock.
