12
■
Operation
CAUTION
CAUTION
• Malfunctions may occur due to electrical noise during momentary power
failures, lightning strikes, high-capacity motor startup, etc. If the product
shuts down abnormally for one of these reasons, perform a reset. If this
occurs frequently, use the anomaly detection sensitivity adjustment (P.10)
to set the sensitivity to LOW.
• When performing a reset using the power switch, once you have turned
the power OFF, wait 10 seconds or more before turning it ON again.
• If the power is repeatedly turned ON and OFF in short cycles, a load will
be placed on the internal transformer, etc. and shorten the life of the
device. Try to leave 5 minutes or more for each continuous recurring cycle
between ON and OFF.
Ion balance adjustment
This product can enables to adjust ion balance.
If the balance of positive and negative ions produced by the electrode is off, the static electricity
cannot be removed, or instead, it is produced. This product can output DC voltage in addition to the
AC high voltage output. By manipulating this DC voltage, the ion balance can be adjusted.
There is an adjustment knob on the other side of the connectors.
Turning the knob labeled (ION BALANCE ADJ) to the left or right
increases or decreases the DC voltage, adjusting the amount of
positive and negative ions produced by the ionizer.
Carry out adjustments by measuring the actual ion balance with
a CPM (charged plate monitor) etc.
IF THE PRODUCT HAS BEEN PURCHASED AS A SET WITH AN IONIZER, THE ION BALANCE
HAS BEEN ADJUSTED BEFOREHAND BASED ON PRE-DETERMINED STANDARD USAGE
CONDITIONS. BECAUSE THE ION BALANCE WILL VARY DEPENDING ON INSTALLATION
DISTANCE, USE OF COMPRESSED AIR, ETC., IT IS RECOMMENDED TO PERFORM ION
BALANCE ADJUSTMENT BASED ON ACTUAL USAGE CONDITIONS.
CAUTION
CAUTION
• If the ion balance is an important factor in the location where this product is
used, use with just 1 ionizer connected to the unit. The ion balance cannot
be individually adjusted for each ionizer when multiple models are
connected to the same power supply unit. For example, if 2 ionizers are
connect to the same unit, and the ion balance is adjusted for one of the,
ionizers the ion balance of the other ionizer may not be as expected.
• Ion balance adjustment cannot be carried out for "SSB bar series".
For other ionizers, please consult the instruction manual for each model.
