Vessel GT-CD60-34, Инструкция по эксплуатации

Страница: 9 / 40

How to Use
8
・
Do not use the tool:
* if the accessories has not been mounted properly.
* if the any accessories have not been attached properly.
* if the work environment does not allow you to keep a stable posture,
secure a firm grip on the tool or to operate the tool properly.
* if the floor is slippery or not level.
* if the attached blade or other accessories are not intended for the use or
application.
* if it has been modified or has any parts missing or lost.
* if the input air pressure is higher than the specified value.
* if more than the specified working torque is required.
・
When the tool is not in use or left unattended, shut off the air supply
and detach the air hose from it.
Preparations before use
● Check the air pressure
The specified air pressure for this air tool is 0.6 MPa. If the input air
pressure surpasses this specified level, it will cause damage on the unit or
individual parts.
● Remove the drain
When moisture or impurities like rust in the pipe get into the mechanism, it
may cause malfunction. Remove accumulated drain in the compressor
before use. To secure dry air supply, install an air filter in order to prevent
moisture and any impurities.
● Use an appropriate air hoses
Please refer to Specifications for choosing an air hose of the appropriate
size for the applied air supply. If the internal diameter of the air hose is too
small, sufficient power may not be obtained as air pressure cannot
increase efficiently. It also happens when the hose is too long.
● Install the plug
・
GT-CD60-34
Use a spanner of No.17 to hold Air Inlet Bushing
and fasten the plug.
・ GT-CD60-34L
Use a spanner of No.19 to hold Air Inlet Bushing
and fasten the plug.