Vessel GT-3800PX, Инструкция по эксплуатации

Страница: 9 / 20

How to use the tool
8
connected hoses.
●
Turning the tool on for the first time following purchase
When first installing this device after purchase or when changing the
hoses, blow out any dirt in pipes and hose before installation. Also, it is
necessary to idle the device for a few seconds because oil in this tool is
expelled with the exhaust.
●
Lubrication
Lubricate for the lubrication of the motor and exhaust impurities. It is easy
to supply lubricant if the lubricator is installed in the piping because the
lubricator will automatically drip lubricant in the tool. Or, you can lubricate
manually from the air supply port before or after use. (Oil: ISO VG10 or
equivalent hydraulic oil.)
●
Tool Tips (Sockets/bits/extension bars, etc.)
When using the tip of the tool for manual operation there is a risk of
accident as the tip of the tool may become damaged and shatter, etc. Be
sure to use power tools for this device.
●
Tightening bolts/nuts
To tighten bolts/nuts, first tighten bolts/nuts by hand for 1-2 revolutions or
a couple of thread pitches. After tightening is complete, immediately let
the lever released and stop the tool. By continuing to tighten further, bolts
could be broken and wear / tear on parts of the hammer will accelerate.
●
When bolts/nuts do not loosen
When bolts/nuts do not loosen or when the torque does not tighten as
expected, an impact wrench with greater power is necessary.
●
Using for unintended purposes
Do not throw or beat on the tool because it causes damage to the unit. Be
aware that dripping the tool in the organic solvents will deform the tool.
●
Use in cold areas
Moisture collected internally may freeze in winter. Be sure to oil following
use and store in a safe place after removing any moisture.