Vessel GT-3800PX, Инструкция по эксплуатации

Страница: 10 / 20

How to use the tool
9
How to use the tool
●
Starting and stopping
１．
Connecting the air coupling.
２．
Supply air with the compressor.
３．
When the start lever is pulled or pushed,
the function starts.
４．
When the start lever is released (disengaged),
the function stops.
５．
When the start lever is pulled (pushed) fully,
it rotates at a high speed and when it is
pulled (pushed)slightly it rotates at a low speed.
●
Changing the direction of rotation.
When the right/left switch lever is set to "R,"
it rotates clockwise.
When it is set to "L," it rotates counter
clockwise.
Do not operate the rotation switch while
pressing the start lever.
●
Adjusting the torque.
Torque adjustment is possible by aligning the
right/left switch lever mark with the numbers. "1" is
the minimum and "3" is the maximum.
●
Installing sockets.
There is a pinhole on the point of the anvil (
□
drive part). Align the
pinhole of the socket and attach the socket with the pin and O-Ring.
Install as shown in the figure.
* It is very dangerous because if it is not securely attached, the socket
may detach and fly off. Do not attach the socket when the tool is idling.
About handling
* Do not touch any rotating parts. It is very dangerous and could lead to
injury.
* Do not idle the tool with the tip of the tool without a load.