Vessel GT-3800PX, Инструкция по эксплуатации

Страница: 8 / 20

How to use the tool
7
・
For handling and operation, be sure to follow the procedures in the
instruction manual.
・
The following uses are prohibited.
* When the sockets or bits are incorrectly installed nor fit properly in size.
*When the work stance is unstable or when the tool is not properly held and
cannot be operated.
* The work environment is slippery or unstable.
* Use in work other than tightening and loosening screws.
* When it has been remodeled and the parts are inadequate.
* Use with more air pressure than shown in the specifications.
*Use in conditions that exceed the recommended load of this product.
・
When not in use or in the absence of the operator, stop the air
supply and remove it from the pipe.
Preparation before work
●
Confirmation of air pressure
The air pressure of this product is 0.6MPa. Be sure not to use air
pressure exceeding the specifications since it influences performance,
lifespan and safety.
●
Removal of the drain
When impurities such as moisture and rust in the pipes enter this product,
it could lead to a malfunction. Clean the drain in the compressor before
use. To supply normal dry air to this product, be sure to install the air filter
and remove any moisture or dirt.
●
Selection of hoses
Refer to the specifications for the size of the air hose for the air supply.
When the internal diameter of the air hose is too small, sufficient power
cannot be exerted due to a drop in pressure. Note a similar pressure drop
is also generated if the hose is too long.
●
Air coupling
When using the attached air coupling, purchase a compatible hose and
connect. When installing a hose directly in this product, purchase a hose
connection coupling separately. In both cases, confirm the size of the