VESPA GTV 250 i.e., Руководство пользователя

Страница: 51 / 80

03_26
03_27
03_28
3. Remove the rubber cap «T» to reach the bulb holder, turn the ring nut « S » and take
out the high-/low-beam light bulb. «1»; to facilitate access unscrew the screw «V» as
well.
4. To replace the tail light bulb «L», in the headlight, remove the rubber bulb holder
from its seat by pulling it slightly.
5.To refit, repeat the operations but in reverse order.
To remove the tail light on the shield, proceed as follows:
1: Remove the screw « A » of the front shield grille.
2: Rotate the front shield grille.
To replace the tail light, pull out the rubber lamp holder from its fitting. To reassemble,
repeat the operation in the reverse order.
Headlight adjustment (03_29, 03_30)
Proceed as follows:
1 . Place the vehicle in running order and with the tyres inflated to the prescribed pres-
sure, on a flat surface 10 m away from a white screen situated in a shaded area,
making sure that the longitudinal axis of the vehicle is perpendicular to the screen;
2 . Turn on the headlight and check that the borderline of the projected light beam on
the screen is not lower than 9/10 of the distance from the ground to the centre of
vehicle headlamp and higher than 7/10;
3 . Otherwise, adjust the headlight operating on the set screw « R » reached from under
the front mudguard.
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EUROPEAN STANDARDS RE-
GARDING MAXIMUM AND MINIMUM HEIGHT OF LIGHT BEAMS. REFER TO THE
STATUTORY REGULATIONS IN FORCE IN EVERY COUNTRY WHERE THE ve-
hicle IS USED.
51
3 Maintenance