LaserCOMPACT Product Manual
VESDA
®
8
Version 1.0
3. Assembly Description
3.1 Assembly
Description
The components of the LaserCOMPACT are housed inside a grey plastic enclosure with a decal
fascia on the front cover and a metal back panel. The front cover is removable and is secured to
the enclosure with two screws located on the left and right hand side of the cover. The plastic tie
attaches the cover to the enclosure, is removable and is used to prevent strain on the cable
loom. The detector contains two parts:-
a) The Front Cover
The front cover (Refer to Figure 5 and Section 3.2) houses the following components:-
•
5 LEDs to indicate Fire, Pre-Alarm, Fault, OK and Reset/Isolate states
•
Reset/Isolate Push Button Switch
b) The Main Enclosure
The main enclosure (Refer to Figure 4 and 6) houses the following components:-
•
Termination Card (Refer to Section 3.3)
•
Cable Entry Ports (Refer to Section 3.4)
•
Air Inlet Port (Refer to Section 3.5)
•
Air Filter Cartridge(Refer to Section 3.6)
•
Aspirator (Refer to Section 3.7)
•
Air Exhaust Port (Refer to Section 3.8)
•
Laser Detection Chamber (Rear of enclosure, refer to Section 3.9)
•
Central Processing Card (Rear of enclosure, refer to Section 3.10)
Figure 4 View of LaserCOMPACT with Front Cover and Enclosure joined
Air Inlet Port
Cable Entry Ports
(One port on rear)
LED Indicators
Qty (5)
Main Enclosure
Front Cover
Decal
Fascia
Air Exhaust Port
(Bottom of Enclosure)
Screws
