Vesco Turbinator-2, Руководство по сборке

Страница: 4 / 19

Periodically exercise the hinges while the glue is setting to insure they aren’t sticking. Use SLOW SET epoxy
during this operation.
You can install the Flap hinges at this time also using the flat hinges. Make sure the hinges are properly aligned
with the slots before gluing.
Once the glue has set on the control surface you can then install the control surface onto their respective wing
or stabilizer. Take great care and insure that you have proper alignment and that there is sufficient
throws/travel on each control surface.
The Flaps should be set to allow for at least 70 degrees of deflection.
The Ailerons and Rudder should have ¾ inches of travel .
The elevator should have 1 inch of travel.
4) While the hinges are drying this is a good time to install servos on the servo covers. Find the covers for
the flaps and ailerons. We recommend at least 150 in oz of torque for all servos. We are running Hitec 5645mg
at 6 volts.
As an added security measure, I have added a layer of double sided tape to each hinge to help secure it to the
cover. Although not necessary it certainly has saved me some headaches in various models over the years.
This is also a good time to install the servos in the fuselage for the Elevators and rudder.